The Built-in Configurator
Access via a Telnet Session
4-4
WaveLAN/EC-S User’s Guide
Access via Direct Telnet Connection
4
If this is the first time you are installing a WaveLAN/EC-S device,
you may need to perform a number of preparatory steps:
1.
Does your computer have the TCP/IP protocol, and the Telnet
program installed?
■
If Yes, proceed with step 2.
■
If No, follow the instructions of the user documentation that
came with your computer and/or operating system to
install the TCP/IP protocol and Telnet software.
2.
Ensure that your computer is set to use a unique IP Address
value in a subnet range that matches the current configuration
of the WaveLAN/EC-S device.
■
For “out-of-the-box” WaveLAN/EC-S devices which use IP
Address 10.10.10.128, change the IP Address of your
computer to the value 10.10.10.130.
■
When trying to access a previously configured device, set
the IP Address of your computer to a unique IP Address
value in the same subnet range as the one assigned to the
WaveLAN/EC-S device.
If you do not know the current IP Address value of the
WaveLAN/EC-S device press the Reset/Config button for
5 seconds to reset the unit to its factory-set defaults, and
proceed as described in the previous bullet.
3.
Ensure that both WaveLAN/EC-S device, and your computer
use the same subnet mask value.
■
For “out-of-the-box” WaveLAN/EC-S devices, set your
computer to use the subnet mask 255.255.255.0.
■
For previously configured devices, set the subnet mask to
the same value as the WaveLAN/EC-S device, or reset the
unit to its factory-set defaults as described above.
4.
Once finished, turn to “Open the Telnet Session” on page 4-6
to launch the built-in configuration tool.
