The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Programming the Options
Page 7-6
7
■
After pressing “0,” “1,” or “2”
or
pressing”#”, one of the
following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green
call appearance lights go on and, if you have a display, a
confirmation message is displayed.
If the voice terminal cannot save this selection, the first three
red call appearance lights go on and, if you have a display, an
error message is displayed. In this case, the selected option
will be in effect until power is removed from the set. If this
happens, try repeating the process. If the option still cannot
be saved, the terminal may be faulty.
Enabling/Disabling the Status Lights for the
PassageWay Connection (For the 8411 Voice
Terminal Only)
If a PC for the PassageWay Solution has been connected to the RS-232-D jack
on the rear of the 8411, the user can use Button #9 (the next-to-last button in the
second column) to see the status of the PassageWay connection. For a list of
PassageWay indications, see “PassageWay and Analog Adjunct Status
Indications on the 8411” in Chapter 3: Installing Your Voice Terminal in this
manual.
To enable or disable the status lights for the PassageWay connection:
1. While on-hook, press
.
■
The light next to
goes on.
2. Press .
■
The light next to
goes off.
3. Enter the 2-digit code, “79” (“PW”).
■
The red and green lights next to Button #9 flutter.
■
The current setting (ENABLE PWY STATUS LAMPS or DISABLE
PWY STATUS LAMPS) is shown on the display, if there is one.
4. Press either “1” or “2” to change the setting:
— Press “1” to enable the status lights for the PassageWay connection
(next to Button #9)
— Press “2” to disable the status lights for the PassageWay connection
(so the button is used as a call appearance button or a feature
button)
or if the voice terminal has a display, press
to change the
setting. Press
to save the desired option and then exit
programming.
Shift
Shift
Mute
Shift
*
#
