The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
The Test Feature and the Diagnostics Feature
Page 6-2
The Test Feature (For ALL 8400-Series Voice Terminals)
6
— On the 8405, 8410, and 8411, the lights go on in two groups,
and the display, if there is one, fills in all the segments
— On the 8434DX, the lights go on in four groups, and the
display fills in all the segments
2. Release
to end test.
■
Lights return to pretest state.
■
Light next to
goes off.
NOTE:
You can test the tone ringer on your voice terminal by pressing either
side of the Volume control button when the handset is on-hook and
the speaker is not in use.
The Diagnostics Feature
(Used ONLY with the 8411 Voice Terminal)
On the 8411 voice terminal, the user can use the Diagnostics feature to monitor
the status of the PassageWay connection and the Analog Adjunct. Use the
following procedure.
1. Press .
■
The red light next to
goes on steadily.
2. Press .
■
The light next to
goes off and the light next to
flutters
intermittently.
■
The red and green lights go on next to Buttons #9 and #10 and an
appropriate display message appears on the 8411 display screen to
indicate the status of these two functions. (If optioned, Button #9 is
always used to monitor the status of the PassageWay connection.
Button #10 is always used to monitor the Analog Adjunct.) For more
information about the meaning of these diagnostics lights, see
“PassageWay and Analog Adjunct Status Indications on the 8411” in
Chapter 3: Installing Your Voice Terminal in this manual.
NOTE:
If you press any voice terminal buttons or if you receive or place a call during
the diagnostics test, the test is terminated and the voice terminal returns to
Normal Mode.
Test
Test
Shift
Shift
Test
Shift
Test
