The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Installing Your Voice Terminal
Page 3-11
Wiring Information
3
Refer to the section, “Attaching Adjunct Equipment” later in this
chapter, for information about connecting any 8400-Series voice
terminal to the wall jack when an adjunct is used.
Refer to the sections, “Connecting a Personal Computer and an Analog
Adjunct to the 8411 Voice Terminal,” later in this chapter, for information
about connecting a personal computer to an 8411 voice terminal for use
with the Lucent Technologies PassageWay Solution software or connecting
the 8411 voice terminal with analog equipment such as an answering
machine, fax machine, or modem.
9. Lift the handset and listen for dial tone. If there is no dial tone, check all
wire connections to make sure they are secure. Also, perform a self-test to
see if the terminal is receiving power from the switch. (See “Using the Test
Feature and the Diagnostics Feature” in Chapter 6: The Test Feature and
the Diagnostics Feature in this manual.)
Adjusting the 8405D, 8405D Plus, and 8410D
Voice Terminal Desktop Stand
To ensure better display visibility on the 8405D, 8405D Plus, and 8410D sets, the
accompanying desktop stand can be installed in a high or low position. (When
each of these voice terminals is shipped from the factory, the stand is in the low
position.) Figure 3-5 shows you the set of tabs to use for each position. Check
which position allows the user the best viewing angle of the display, and then use
the following short procedure for installing the desktop stand in the selected
position.
To reinstall the desktop stand on the 8405D, 8405D Plus, and 8410D voice
terminal for the low or the high position (See Figure 3-5.)
1. Place the lower desktop stand tab in the appropriate voice terminal tab slot.
2. Slowly lower the desktop stand until the top tab fits into the appropriate tab
slot at the top of the voice terminal. You may need to press inward on the
top of the desktop stand (see Figure 3-5) in order for the tab to fit into the
slot.
NOTE:
As noted before, if you choose to install the desktop stand in the high
position, you may need to pass the cords through the long,
rectangular opening that surrounds the jacks and then plug the cords
into the jacks BEFORE you place the stand on the back of the voice
terminal.
