The 8400-Series Voice Terminals Instructions for Installation, Switch,
Administration, and Programming the Options
555-015-725
Issue 1
October 1996
Installing Your Voice Terminal
Page 3-10
Wiring Information
3
Figure 3-4.
Line, Adjunct, Handset, & Expansion Module Cord Routing on the 8434DX
Voice Terminals
6. Turn the voice terminal right side up, with the front facing you.
7. Snap the free end of the handset cord into the handset and place the
handset in the cradle.
8. Snap the free end of the line cord into the modular wall jack.
NOTE:
If you are installing an 8411 or 8434DX, connect the voice terminal
line cord to the PHONE jack on the MSP-1 power supply and then
connect a cord from the LINE jack on the MSP-1 to the wall jack.
You can use a 2-wire/4-wire adapter to upgrade an analog-type
RJ11C jack to an 8-wire RJ45X-type jack. For more information,
see “The 2-Wire/4-Wire Line Adapter” earlier in this chapter.
Adjunct
Handset
Line jack
> ABS<
NOTE: The location of the jacks and the routing channel
USE ONLY WITH
COMMUNICATION
CIRCUIT POWER
SOURCE
!
U
L
LISTED
91B0
Telephone
Equipment
®
HAC
Lucent Technologies
MADE IN U.S.A.
Expansion
module jack
on the back of your voice terminal may differ slightly
from the location shown in this figure.
Routing channel
EX MOD
LINE
jack
jack
