Lucent Technologies Stinger, Administration Manual

Page: 137 / 374

Monitoring Interfaces on LIMs and Trunk Modules
Monitoring LIM and LIM port redundancy
Stinger® Administration Guide 5-19
3 2 1
6543 2109 8765 4321 0987 6543 2109 8765 4321
.... .... .... .... .... .... .... .... ....
Test Bus usage : not applicable
Note Slots that are equipped with interface redundancy modules (IRMs) or LPMs
with redundancy (LPM-Rs) in older Stinger units are reported as Empty by the
rearslotshow command.
Note When a copper loop is being tested on a Stinger LS with a PSM or a CLT
module, the
rearslotshow
command does not display any midplane sparing bus
usage.
Displaying redundancy or ignore-lineup settings for LIM ports
The splimports command displays ports that are enabled for automatic or manual
redundancy or the ignore-lineup feature. (This feature allows the unit to accept calls
on a port whether the line state is UP or DOWN, as long as the slot is operational and
the port is enabled.) To display syntax information, enter the command without any
arguments or see the
Stinger Reference .
The following sample command displays ports in slot 7 that are enabled with the
systemwide setting for the ignore-lineup feature:
admin> splimports -i -s 7
Line Type
--------------------
1-7-2 ADSL
1-7-7 ADSL
1-7-11 ADSL
...
...
...
1-7-22 ADSL
1-7-23 ADSL
1-7-24 ADSL
The following sample command displays all ports that are disabled for the ignore-
lineup feature:
admin> splimports -i -n
Line Type
--------------------
1-7-1 ADSL
1-7-4 ADSL
1-7-5 ADSL
1-7-6 ADSL
1-7-9 ADSL
1-7-14 ADSL
1-16-21 HDSL2
1-16-22 HDSL2
1-16-23
HDSL2