3-6
Stinger®
IP2000 Configuration Guide
VLAN Configuration
Configuring a local management VLAN
admin> set bridging-options bridging-group = 34590
admin> write -f
Then create a
onnection
profile on that interface for the LIM side of the VLAN bridge
circuit. The following commands create a connection profile for the
{ 1 2 1 }
LIM
interface (nailed group
51
):
admin> new connection dslcpe
admin> set active = yes
admin> set encapsulation-protocol = atm
admin> set bridging-options bridging-group = 34590
admin> set bridging-options bridge = yes
admin> set atm-options vpi = 8
admin> set atm-options vci = 100
admin> set atm-options nailed-group = 51
admin> write -f
Following is a comparable RADIUS profile for the LIM interface side of the VLAN
bridge circuit:
permconn-st-1 Password = "ascend"
Service-Type = Outbound,
Framed-Protocol = ATM-1483,
User-Name = "dslcpe",
Ascend-Route-IP = Route-IP-Yes,
Ascend-ATM-Group = 51,
Ascend-ATM-Vpi = 8,
Ascend-ATM-Vci = 100,
Ascend-Bridge = Bridge-Yes,
Ascend-BIR-Bridge-Group = 34590
The LAN session should come up, displaying log messages such as the following:
LOG notice, Shelf 1, Slot 2, Time: 20:24:02--
Line 1 up
LOG info, Shelf 1, Controller-1, Time: 20:24:02--
[1/2/1/0] Assigned to port [MBID 1]
LOG info, Shelf 1, Slot 2, Time: 20:24:02--
[1/2/1/0] LAN session up: <dslcpe> [MBID 1] [dslcpe]
The following command shows the active session:
admin> users
SessionID
Line/Chan
Slot:Item
Tx/Rx Rate
Svc
Address
Username
385031879
1.02.01/000
1:02:01/000
8000K/832K
ATM
0.0.0.0
dslcpe
<end user list> 1 active user(s)
For information about low-level diagnostic commands for viewing bridge tables, see
Appendix A, “IP2000 Diagnostics.”
Configuring a local management VLAN
You can configure a virtual IP interface as a management VLAN, to isolate
management traffic and provide additional security for the logins to the system. Like