Lucent Technologies STGR-LIM-VD-24, Manual, Page: 70 / 102

............................................................................................................................................................................................................................................................
Bit rate parameters The VDSL-Config subprofile
4 - 1 2 363-217-032R9.9.0
Issue 2, March 2006
............................................................................................................................................................................................................................................................
Bit rate parameters
Introduction
The
vdsl-config:interleave-path-config
subprofile, bit rate parameter settings are
configured to control the use of the interleave path channel for both upstream and
downstream VDSL traffic.
Default settings
[in AL-DMT/{ any-shelf any-slot 0 };vdsl-config:interleave-path-config]
min-bitrate-up = 100
min-bitrate-down = 1000
max-bitrate-up = 30000
max-bitrate-down = 6000
planned-bitrate-up = 0
planned-bitrate-down = 0
Parameter descriptions
Parameter Setting
min-bitrate-up
Specifies the minimum requested bit rate for upstream traffic
in Kbps, from 0 through 60000.
The default value is 100.
Important! Not valid for the rate adaptation setting of
operator-controlled .
min-bitrate-down
Specifies the minimum requested bit rate for downstream
traffic in Kbps, from 0 through 80000.
The default value is 1000.
Important! Not valid for the rate adaptation setting of
operator-controlled .
max-bitrate-up
Specifies the maximum requested bit rate for upstream traffic
in Kbps, from 0 through 60000.
The default value is 30000.
Important! Not valid for the rate adaptation setting of
operator-controlled .