Lucent Technologies STGR-LIM-VD-24, Manual

Page: 64 / 102

............................................................................................................................................................................................................................................................
VDSL-Config:Spectrum-Config subprofile The VDSL-Config subprofile
4 - 6 363-217-032R9.9.0
Issue 2, March 2006
............................................................................................................................................................................................................................................................
VDSL-Config:Spectrum-Config subprofile
Introduction
Parameter settings in this subprofile are used to configure spectrum usage when the
dsl-
type
parameter, in the AL-DMT profile, is set to
vdsl
.
Default settings
The following listing illustrates the default settings of the AL-DMT:VDSL-
Config:Spectrum-Config subprofile.
[in AL-DMT/{ any-shelf any-slot 0 }:vdsl-config:spectrum-config]
bandplan = bp-998
u0-band = a-25-138
scenario = cabinet
etsi-variant = a
up-psd-template = m1
down-psd-template = m1
notch-config = { no no no no }
adsl-presence = none
adsl-friendly = no
Parameter descriptions
The following table describes the functions associated with the available parameter
settings in the AL-DMT:VDSL-Config:Spectrum-Config subprofile.
Parameter Setting
bandplan
Specifies the VDSL band plan. Valid values are:
998
—(the default) VDSL band plan 998 is enabled.
997
—VDSL band plan 997 is enabled.
u0-band
Specifies if the U0 band is used and sets the bandwidth. Valid values
are:
none
—The U0 band is not used.
a-25-138
—(the default) The U0 band is set to extend from
25KHz to 138KHz.
b-138-276
—The U0 band is set to extend from 138KHz to
276KHz.
m-25-276
—The U0 band is set to extend from 25KHz to 276KHz.