Lucent Technologies PARTNER Endeavor 362, Programming And Use Manual

Page: 113 / 407

Feature Reference
5-14
■
PARTNER-6 phones have only four buttons available for lines, pools, and/or
Auto Dial numbers.
■
A combined total of 576 outside Auto Dial and Personal Speed Dial
numbers can be programmed.
■
For PBX or Centrex systems that require a dial-out code to make calls
outside the PBX or Centrex system, include the dial-out code followed by
one or more pauses (if available) on an Auto Dial button for a number
outside the PBX or Centrex system. (See “Changing Settings to Support
PBX or Centrex Services” in Chapter 2 for more information.)
Examples
The examples below show some possible entries for an Auto Dial number in
Step 4 of “Programming” below.
■
Outside Phone Number. Enter the phone number (up to 28 digits) exactly
as you would dial it. For example, to program 555-2398, press
5 5 5 2
3 9 8
.
■
Extension Number. Press the left
i
button and enter the two-digit
extension number. Press
*
before the extension number to program the
Auto Dial button to voice signal an extension. For example, to program
extension 20 for voice signaling, press
i * 2 0
. The display
reads:
Intercom *20
■
Feature Code. Enter the appropriate code. For example, to program a
button to turn on the message light at extension 20, press
f 0 9 2
0
. When you press the programmed button, the Message Light at
extension 20 turns on.
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
such as
s
and
e
on system phones.)
To program an Auto Dial button:
1. Press
f 0 0 s s c
at extension
10 or 11.
2. Enter the number of the extension to be programmed.
3. Press a programmable button.
4. Enter an outside phone number, feature code, or PBX/Centrex feature
access code; or press left
i
and enter an extension number.
5. Repeat Steps 3 and 4 to program additional Auto Dial buttons, or exit
programming mode.