Chapter 3 Configuring Ports and Channels Using the Console
Configuring the Ports
3-10
255-700-585
PacketStar
®
PSAX 3-Port DS3/E3 ATM Protection Module User Guide
, Issue 1
Release 10.0.0
The Protection 3-Port DS3 ATM Configuration window (see Figure 3-8)
is displayed.
Commands
The commands in this window have the following functions:
Figure 3-8. Protection 3-Port DS3 ATM Configuration Window
Command
Function
Apply Operating Mode
Change
Changes the signaling mode in which the module will
operate. After selecting the value
DS3
in the Operating
Mode field, select this command to apply the change. The
module reboots and the window reflects your selection.
Note:
All interfaces must be unconfigured, out of service,
and deleted before using this command.
Update Display
Updates the values in the fields to show the most current
configuration. Use this command to display the most cur-
rent information in the Line Status field.
Delete All Interfaces
Deletes the configured interfaces for the three ports. You
must take all interfaces out of service (using the
Take All
Interfaces Out Of Service
command) before you can use
this command to delete all the configured interfaces.
Bring All Interfaces Into
Service
Brings the out-of-service configured interfaces for the three
ports to in-service status.
Take All Interfaces Out Of
Service
Takes the in-service configured interfaces for the three
ports to out-of-service status. You must use this command
first before using the
Delete All Interfaces
command.
Go Back to Equipment
Configuration
Redisplays the Equipment Configuration window.
