ORINOCO WavePOINT-II - Getting Started
C-1
C
Additional Installation
Instructions
Removing the Cover Plate
C
Removing the cover plate of the ORiNOCO WavePOINT-II AP may be
required in one of the following situations:
■
You would like to change or replace the network interface(s) of your
access point, or
■
You would like to access the ‘Reboot’ and/or ‘Forced Reload’ buttons on
the access point processor module.
To remove the ORiNOCO WavePOINT-II AP cover plate:
1. Place your hands on the cover as pictured Figure C-1.
2. Gently pull the top of the cover towards you to release the latches
(located inside the cover).
