MERLIN LEGEND Communications System Release 7.0
System Programming
555-670-111
Issue 1
April 1999
Programming Procedures
3-607
Night Service
3
n
Activate/Deactivate Night Service Procedure
3
Console/Display Instructions
Additional Information
PC
1.
Turn Night Service
On
or
Off.
2.
Save your entry.
Select
Enter.
3.
Return to the System Programming menu.
Select
Exit.
Night Service with Coverage Control
3
Use this procedure to enable or disable the Night Service Coverage Control
option to automatically control the status of programmed Coverage VMS Off
buttons.
When the Coverage Control option is enabled, a transition into Night Service
(either by pressing a Night Service button or automatically by the Time Set option)
automatically deactivates the VMS Coverage Off (Release 2.0 or later) buttons
(LED is off) and allows outside calls to go to VMS Coverage at night. When the
system is taken out of Night Service (either by pressing a Night Service button or
automatically by the Time Set option), programmed VMS Coverage Off buttons
are activated (LED is on) and outside calls are prevented from going to VMS
Coverage during the day.
When the Coverage Control option is disabled, Night Service status has no effect
on programmed VMS Coverage Off buttons.
Summary: Night Service with Coverage Control
3
Programmable by
System Manager
Mode
All
Idle Condition
Not required
Planning Form
9c, Night Service: Options
Factory Setting
Disabled
Night Serv Time Control:
Select
On
to turn Night Service on.
Select one
Select
Off
to turn Night Service off.
On
Off
Exit
Enter