MERLIN LEGEND Communications System Release 7.0
System Programming
555-670-111
Issue 1
April 1999
Programming Procedures
3-103
Uniform Dial Plan Facilities
3
Console/Display Instructions
Additional Information
PC
5.
Enter the last trunk number in the block to copy to.
6.
Save your entry.
Select
Enter.
7.
Return to the System Programming menu.
Select
Exit
three times.
Uniform Dial Plan Facilities
3
Release 6.0 and later systems, Hybrid/PBX mode only, provide support for
Uniform Dial Plan (UDP) facilities, private network tandem lines/trunks originating
at one or more other MERLIN LEGEND Communications Systems or DEFINITY
Communications Systems. Use the procedures in this section to program the
switch identifiers for private network trunks.
Switch Identifiers
3
Switch identifiers are 1- or 2-digit prefixes that appear in print reports and are
used by the system for transmission level determination, route checking, and to
identify calls. If your system uses private facilities, you must program switch
identifiers. Switch identifiers indicate the switch connected to the far end of a
private trunk.
The procedures in this topic allow you to add, change, and remove switch
identifiers.
Trunks connected to your system from the central office do not require identifiers.
They are, by default, correctly assigned a null identifier.
When a private networked trunk is deleted, it is assigned a null identifier, as are
trunks newly added to the system.
START at Trunk xxx To:
xxx
= “start copy to” trunk entered
Enter ending trunk
in Step 3
number
Dial or type:
Ã
Trunk number
[nnn]
Backspace
Slot and port number
*
[sspp]
Exit
Enter
Logical ID number
#[nnn]
