MERLIN LEGEND Communications System Release 7.0
System Programming
555-670-111
Issue 1
April 1999
Programming Procedures
3-28
System Renumbering
3
Block Renumbering
3
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
!
CAUTION:
Select
Exit
on the console, or
on the PC, when you have finished
renumbering extensions. If you press Home, extensions may remain in the
forced idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
Summary: Block Renumbering
3
Programmable by
System Manager
Mode
All
Idle Condition
System idle
Planning Form
2a, System Numbering: Extension Jacks
2b, System Numbering: Digital Adjuncts
2d, System Numbering: Special Renumbers
Factory Setting
Not applicable
Valid Entries
Old and new extension numbers
Inspect
Yes
Copy Option
Yes
Console Procedure
SysRenumber
→
Block
→
Select type of group
→
Dial
no. of first group member
→
Enter
→
Dial no. of last
group member
→
Enter
→
Dial new beginning no.
→
Enter
→
Exit
→
Exit
→
Exit
PC Procedure
→
→
Select type of group
→
Type no. of first
group member
→
→
Type no. of last group
member
→
→
Type new beginning no.
→
→
→
→