B-6
MAX 3000 Installation and Basic Configuration Guide
Upgrading the MAX 3000
Adding a compression/encryption module
2
When the system tray is securely in the cover, use the Phillips screwdriver to tighten the
screws that fasten the system tray to the cover.
Adding a compression/encryption module
To add a compression/encryption module, you remove the MAX unit’s system tray, located the
socket for the module and insert the module, and put the system tray back into the cover.
!
Caution:
When installing any card or module, be sure to follow proper procedures (such as
using a grounding mat and a wrist strap) to prevent buildup of static electricity.
Remove the system tray from the MAX cover
To remove the system tray from the MAX cover, perform the steps outlined in “Remove the
system tray from the MAX cover” on page B-2.
Warning:
Failure to turn off the MAX power and unplug the power cord could result in
bodily injury.
