Lucent Technologies Lineage
®
2000 ECS-6U Controller J85501E-1
4 - 18 Installation and Setup
Issue 4 August 1998
Optional 248A
Order Wire Board
The Order Wire Board shown in Figure 4-13 is optional for the
plant. This feature should be ordered when the plant will be
monitored over the FT-Series G embedded maintenance system.
Additional equipment and connections are required outside the
power bay to establish the communication link over the
FT-Series G embedded telemetry system.
For each repeater site, an SM535 circuit pack (J98764R-1, L45)
is required for order wire slot 4 of the LRBC. An SM534
(J98764T-1, L15) circuit pack is also required at the terminal
site(s) of each route.
The external connections in Table 4-F are required at the back of
the LRBC and TCC (slot 4 is most commonly used) in order to
establish a communication link with the ECS-6U Controller over
the FT-Series G embedded maintenance system.
Figure 4-13: 248A Order Wire Board
E6-TO DISCHARGE BATTERY
VIA WIRE KIT 846832343
P13 - ORDER WIRE SIGNAL LEADS
TO P10 OF ALARM INTERFACE
PANEL, ED-83227-30, VIA
WIRE SET SET 845653765
E5 - TO GROUND VIA
WIRE KIT 846832343
TO J203 ON CP2 OF
ECS CONTROLLER VIA
TELEPHONE CORD
(106595684)
2
J12
3