Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 873 / 2536

RTRV-LINK 2 of 1 Page RTRV-LINK
NAME
Configuration Link CIT Retrieve rtrv-link:
FORMAT INPUT
rtrv-link;
DESCRIPTION
craft user’s the for parameters currently-provisioned the displays command This
the by set as link, interface
set-link
which link the includes This command.
reports. of length page the and rate, baud the into, logged is user the
parameter. provisionable a not is and autobaud by set is rate baud The
follows: as appears report output The
t r o p e R n o i t a r u g i f n o C k n i L e c a f r e t n I * /
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
= k n i L k n i l = ) g p ( h t g n e L e g a P , g p = d u a B , d u a b ) o t u a (
/ *
are: parameters output The
Link
was command the which from link CIT the identifies Link
values: following the have may and executed
cit-1
port. front-access the indicates This
cit-2
port. rear-access The
dcc- x
access remote for used port DCC SONET A
(
dcc-m
,
dcc-a
,
dcc-b
or ,
dcc-c
).
PageLength
report. a of page one in displayed lines of number the is This
be will page one than greater lines of number a with Reports
paged.
Baud
BBG8 the For link. this for rate data the identifies Baud
the with agree to set automatically is rate data CIT the SYSCTL,
( The link. the to connected workstation or terminal
auto
after )
autobaud the by set is rate data the that indicates rate data the
CIT the to connecting After pack. circuit SYSCTL the on routine
carriage (double <CR><CR> or <enter><enter> press port,
OC-3 DDM-2000
2000 February 2 Issue
11-203