Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 832 / 2536

RLS-LPBK-EC1 1 of 1 Page RLS-LPBK-EC1
NAME
Release-Loopback-EC1 rls-lpbk-ec1:
FORMAT INPUT
rls-lpbk-ec1: Address
[:
lpbktype= LoopbackType
];
DESCRIPTION
low-speed a on loopback established previously a releases command This
interface. STS1E
are: parameters input The
Address
released. be to is loopback a where port(s) EC-1 of Address
Addresses: Port EC-1 Valid
{a,b,c,all}
lpbktype
facility or terminal is loopback the whether specifies loopbacktype
terminal
speed high the towards directed loopback terminal
value. default a is This facility.
facility
DSX. the towards directed loopback facility
a release to attempts user the If
facility
address valid a at type loopback
a only when
terminal
to attempts or established, been has type loopback
a release
terminal
a only when address valid a at type loopback
facility
following the and denied be will attempt the established, been has type loopback
displayed: message denial
F O R S
/ * d e l i a F n o i t a r e p O d e t s e u q e R , s u t a t S * /
/ * . t s i x e t o n s e o d k c a b p o o l d e i f i c e p S * /
COMMANDS RELATED
opr-lpbk-ec1
11-162
2000 February 2 Issue
OC-3 DDM-2000