Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 2503 / 2536

363-206-285 Detailed Level Procedure:
DLP-562
Issue 2, February 2000 Page 1 of 12
DDM-2000 OC-3 M
ULTIPLEXER
Install New Software Generic Program
Network Element Software
Remote Shelf Download
In-Service System
1. Before beginning the software installation, refer to the Software Installation
and Upgrade Procedure section of the Software Release Description. This
section contains a description of any special considerations required when
installing this version of software.
2. NOTE:
This procedure uses the
cpy-prog:
or
ins-prog:
commands to install
a new software program in a remote in-service DDM-2000 OC-3 shelf. It
is assumed that the local shelf has already been upgraded and the
software is running normally or has been installed as a dormant copy. For
procedures to download software in a new shelf (initial installation), see
DLP-561. For procedures to download software locally to a shelf, see
DLP-532.
NOTE:
If upgrading from earlier software releases to TARP Release 13.0 and
later, after the first shelf is upgraded, single-ended operations will not be
available and major alarms (
section DCC channel failed
) will exist
until all shelves are upgraded. The node farthest away should be
upgraded first, working back to the local node. See 824-102-144,
Lucent
Technologies 2000 Product Family, Operations Interworking Guide For
TARP Releases, for guidelines in subnetwork upgrade procedures.
Verify that no DCC failures or transmission failures (OC-3 LOS, flashing OLIU
FAULT LEDs, etc.) are present on the network element or system receiving the
program.
3. Use
rtrv-fecom
/
set-fecom
command to verify/enable far-end
communications (fecom).
DLP-561
DLP-532