Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1176 / 2536

TEST-ALM 2 of 1 Page TEST-ALM
NAME
Alarms Office Test test-alm:
FORMAT INPUT
test-alm
:[
md= Mode
][,
r= Repeat
];
DESCRIPTION
user associated and alarms office visible and audible the tests command This
LEDs. panel
it turns and seconds 10 for alarm specific a on turns test alarm office specific The
operation. normal its to reverts alarm office the which after seconds, 10 for off
MJ, (CR, levels alarm various the through cycles test alarm office general The
table: following the in shown as intervals 4-second at MN)
Test Alarm General
LEVEL ALARM Time
MN MJ CR (Seconds) Step
0-4 1
off off off
ON 4-8 2
off off
ON off 8-12 3
off
12-16 4
off off
ON
16-20 5
off off off
executing. is test this while normally functions button (ACO) cutoff alarm The
alarms. office audible silences ACO Depressing
are: parameters Input
md
the takes It performed. be to test alarm office the identifies Mode
values: following
all
(default) alarms office all of test General
cr
alarm critical of test Specific
mj
alarm major of test Specific
mn
alarm. minor of test Specific
r
be should 4 through 2 Steps that times of number the specifies Repeat
of range a with integer an is It repeated.
1
through
10
default a and
of value
1
.
while key "DELete" or "CANcel" the pressing by aborted be can command This
progress. in is command the
11-506
2000 February 2 Issue
OC-3 DDM-2000