Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1169 / 2536

SWITCH-PATH-VT1 3 of 1 Page SWITCH-PATH-VT1
NAME
VT1.5 Path Switch switch-path-vt1:
FORMAT INPUT
switch-path-vt1
:
Address
:
pri= Priority
;
DESCRIPTION
ring protected path on switching path VT1.5 controls command This
(one-way). unidirectional always is switching Path configurations.
are: parameters input The
Address
drop carrying currently path VT1.5 the of address the is Address
executed, is command this When traffic. continue and drop or
on path other the to path this from away switched be will traffic
parameter. this for default no is There ring. the
Addresses: Valid
m{1,2}-{1-3,all}-{1-7,all}-{1-4,all}
slots) Main in OLIU (OC-3
m{1,2}-{1-2}-{1-7,all}-{1-4,all}
slots) Main in OLIU (27-type
{a,b,c}{1,2}-{1,2}-{1-7,all}-{1-4,all}
slots) FN in OLIU (27G2-U
{a,b,c}{1,2}-1-{1-7,all}-{1-4,all}
later) and 13.0 Release slots, FN in OLIU (26G2-U
m{1,2}-{1-12,all}-{1-7,all}-{1-4,all}
later) and 15.0 Release slots, Main in OLIU 29-type or (24-type
as provisioned Connections
ring 0x1
or
locked
be cannot
switched.
NOTE:
a to dropped simultaneously is path continue and drop A
through. passed and interface low-speed
pri
request. switch protection the of priority the indicates Priority
is: value valid only and one The
manual
the from switch a requests parameter This
path a unless path standby the to path addressed
the on exists degrade signal path or failure signal
path. standby
OC-3 DDM-2000
2000 February 2 Issue
11-499