Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1135 / 2536

SET-T1 6 of 1 Page SET-T1
NAME
Characteristics T1 Set set-t1:
FORMAT INPUT
set-t1: address
[:
lc= LineCode
][,
alm= AlarmLevel
][,
fth= FailureThreshold
]
[,
dlc= DLCBPVtoLOS
][,
ais= AlarmIndicationSignal
][,
pmmd= PMMode
]
[,
fmt= Format
];
set-t1: address
[:
pmmd= PMMode
][,
fmt= Format
];
pack) circuit TMUX BBG20 later, and 13.0 Release OC-3 (For
set-t1: address
[:
alm= AlarmLevel
][,
pmmd= PMMode
];
only) pack circuit LAN IMA later, and 15.0 Release OC-3 (For
DESCRIPTION
!
CAUTION:
service. affect may command this of Execution
These ports. DS1 more or one of parameters the sets command This
AIS and thresholds, failure coding, line levels, alarm include characteristics
conditions.
and Mode PM the sets also command this later, and 13.0 Release OC-3 In
TMUX the with associated signals DS1 internal the for parameters Format
packs. circuit (BBG20)
this packs, circuit LAN IMA the using when 15.0, Release OC-3 with Starting
is Format (PM Format. PM and Mode, PM Levels, Alarm the sets command
to set always
esf
).
NOTE:
the all with provisioned automatically is pack circuit protection DS1 The
the for except protects, it pack service the as options user-settable same
CIT). the via provisioned not is (which value (LBO) buildout line
are: parameters input The
Address
One provisioned. be to port(s) DS1 the of address the is Address
specified. be may more or port
Addresses: Valid
{a,b,c}-{1-7,all}-{1-4,all} all,
two supports 15.0) Release (OC-3 pack circuit (BBF6) T1EXT The
1 numbers port only BBF6, a on ports addressing When ports. T1
Specifying valid. are 2 and
all
only. 2 and 1 ports selects
OC-3 DDM-2000
2000 February 2 Issue
11-465