Lucent Technologies DDM-2000 OC-3, User & Service Manual

Page: 1107 / 2536

SET-STATE-OC1 3 of 1 Page SET-STATE-OC1
NAME
State Line OC-1 Set set-state-oc1:
FORMAT INPUT
set-state-oc1: Address:ps=PrimaryState
;
DESCRIPTION
used is command This lines. OC-1 more or one of state the sets command This
line. specified a from failures signal of monitoring the off and on turn to
are: parameters input The
Address
line(s). OC-1 the identifies Address
OLIU): 27-type (for Addresses Line OC-1 Valid
main-{1,2}-{1,2}, main-all, all,
fn-{a,b,c}-{1,2}-{1,2} fn-all,
OLIU): 26G2-U (for Addresses Line OC-1 Valid
fn-{a,b,c}-{1,2}-1 fn-all,
ps
following the of one have may which state line the is PrimaryState
values:
nmon
alarm report not Do monitored. not to state line the Set
line and Section line. the for conditions status or
stopped be will collection data monitoring performance
if in-service to state line the change not Do state. this in
this in remain will line The detected. is signal good a
this with again changed is state the until state
command.
NOTE:
data the NMON, to set is state line the When
disabled. be will (DCC) channel communication
is
good for monitored be to state line the Set In-service.
status alarm, of Reporting line. specified the at signal
state. normal in is data PMON and conditions,
NOTE:
the Use
set-fecom
the enable to command
been have might (that DCC corresponding
NMON). of state previous a of because disbaled
OC-3 DDM-2000
2000 February 2 Issue
11-437