Lucent Technologies CentreVu Supervisor, Installation And Getting Started Manual

Page: 29 / 306

CentreVu Supervisor Version 8 Installation and Getting Started
Introduction
What You Need on Your PC
1-11
●
For Serial Connection
— Serial cable correctly wired to support hardware flow control and a
16550A UART communications port
— Available COM port.
●
For Modem Connection—at least a 19.2 Kbps modem and a 16550A
UART communications port. If the modem is external, then the cable must
be correctly wired to support hardware flow control.
Other Requirements
1
If you are upgrading from Supervisor 1.0 or 5.0 and you are running Windows
3.1, Windows for Workgroups 3.11, or Windows NT 3.51, you must upgrade
your PC operating system to Microsoft Windows 95 or 98 or Windows NT 4.0
before you can install CentreVu Supervisor R8.
If you are installing Supervisor on a Windows 95 or 98 operating system that
does not have Internet Explorer 4.0, you need to install Dcom95 before
installing CentreVu Supervisor. To install Dcom95, run the
dcom95.exe
program located in the Dcom95 folder on your CentreVu Supervisor CD-ROM,
or in the Supervisor folder on the network server. Dcom95 requires you to
reboot your PC, so you need to close any open applications before running it.
If you are running Windows NT 4.0 and do not have Service Pack 4 installed,
you must install it before installing CentreVu Supervisor.
If you have Windows NT 4.0 with no Service Pack, Service Pack 1 or Service
Pack 2, you will need to install Service Pack 3 first, then Service Pack 4. If you
have Windows NT 4.0 with Service Pack 3, you will need to upgrade to Service
Pack 4.