Configuring a CellPipe SDSU
Configuring the DCE interface
CellPipe™ SDSU User’s Guide
4-5
To configure a DLCI port, proceed as follows:
1
From the Main Menu, select
Configure Interface
.
2
Select
Configure DLCIs
.
3
Select
Add New DLCI
.
4
Enter a value for the DLCI.
5
Select
ATM RFC 1483 (Tunneling)
for type of encapsulation.
6
Select
Configure FR Options
to configure fragmentation, maintenance
protocol, and congestion parameters.
Assigning IP addresses for DLCI connections
You also need to assign an IP address to each DLCI on the WAN interface.
To assign an IP address, proceed as follows:
1
From the Main Menu, select
Configure IP Router
.
2
Select
Configure Port IP Address
.
3
Select
SDSL
4
Select a port and assign the appropriate IP address.
Configuring the DCE interface
The DCE interface on a CellPipe SDSU unit can be configured for static and dynamic
routing. In routing mode, the DCE interface can support IP routing over Frame Relay.
To enable routing, you need to configure DLCI connections and assign IP addresses
to these connections. See “Configuring DLCIs” on page 4-4 and “Assigning IP
addresses for PVC connections” on page 4-4.
Configuring static and default routes
A CellPipe SDSU unit can be configured to have a static (or default) route or have
RIP enabled for dynamic routing.
