Lucent Technologies CAJUN M770, User Manual

Page: 87 / 266

Chapter 6 Managing Virtual Ports
Cajun M770 ATM Switch User’s Guide 69
Displaying the method of probing for proprietary features
To display the method of probing for a virtual port, use the
vport probe
command.
Showing Virtual Port Information
Listing the link configuration information for all virtual ports
You can view the link configuration information for all virtual ports or for a specific
virtual port.
Any virtual port information that is marked with an asterisk (*) has been learned
by the M770 ATM Switch during the ILMI dialogue with the remote device.
Information that is not marked with an asterisk has either been configured by the
user or is the default setting for the virtual port.
To view the link configuration information about all virtual ports, enter the
vport show config
command.
Command:
M15-155s8:/>vport probe <vport id>
Output:
Method of probing for proprietary features: MIB
Parameter:
<vport id>
The virtual port in the form
<slot>.<port>.<virtual port number>.
Command:
M15-155s8:/>vport show config [<vport id>]
Parameter:
<vport id>
The virtual port. This is displayed in the format
<slot>.<port>.<virtual port number>.
If a <virtual port number> parameter is not supplied then
the link configuration summary information is displayed
for all virtual ports.
Example:
M15-155s8:/>vport show config
Output:
Virtual Port Configuration Information
Virtual Admin
Oper ILMI Poll Multi Strict Sig. SSCOP Wait for
Port Id State State Enabled Mode Reg AAL Rx. Window Peer SSCOP
8.0.0 Up Up No Disabled On Off Default No
8.1.0 Down Down Yes None On Off Default No
8.2.0 Up Up Yes Port + ESI On Off Default No
8.3.0 Up Down Yes None On Off Default No
8.4.0 Down Down Yes None On Off Default No