Lucent Technologies CAJUN M770, User Manual

Page: 48 / 266

Chapter 4 Managing Miscellaneous Commands
30 Cajun M770 ATM Switch User’s Guide
To change the switch prefix for the M770 ATM Switch, use the
address prefix
command.
Note: You must reboot the switch before the above command will take affect. You
must update all the other affected switches’ static routing table entries with the
new switch prefix. If you are using PNNI routing then the affected routing entries
will be updated automatically.
Resetting the saved switch prefix
You can reset the saved switch prefix to current address. This prevents the current
address from changing even after a reset.
To reset the saved switch prefix, use the
address reset
command.
Setting the switch prefix to its default value
The default prefix is 39.00.00.00.00.00.00.xx.xx.xx.xx.xx.xx where x is the MAC
address of the switch master agent module.
To change the switch prefix for the M770 ATM Switch to its default value, use the
address
default
command.
Command:
M15-155s8:/>address prefix <prefix> [node_id] [pg_id]
Parameters:
<prefix>
The new switch prefix. The prefix must be a 13-
byte address and expressed as 13 two-digit
hexadecimal numbers separated by periods.
(39.00.01.02.03.04.05.06.07.08.09.aa.bb) is an
example of a switch prefix address.
The first byte of the switch prefix address must be
39, 45, 47 or 49. For more information see text in
the introduction to this section.
[node_id]
Optional parameter that indicates that the PNNI
node ID shall be changed according to the new
prefix
[pg_id]
Optional parameter that indicates that the PNNI
peer group ID shall be changed according to the
new prefix
Command:
M15-155s8:/>address reset
Command:
M15-155s8:/>address default
Output:
Done.