Lucent Technologies CAJUN M770, User Manual

Page: 46 / 266

Chapter 4 Managing Miscellaneous Commands
28 Cajun M770 ATM Switch User’s Guide
To set the gateway IP address, enter the
ip gateway
command.
Viewing Cajun M770 ATM Switch IP address information
You can display IP address information for the M770 ATM Switch. For information
about changing the IP address information, see Setting the Cajun M770 ATM
Switch IP address, subnet mask, and gateway earlier in this chapter.
To view the IP address information, use the
ip show
command. The message
“initializing” indicates that the LEC has not yet joined the ELAN.
Viewing the End System Identifier (ESI)
The End System Identifier (ESI), also referred to as the Burnt-In Address (BIA), is
the factory-assigned world-wide unique address for the switch. If the management
LEC on the M770 ATM Switch is joined to an Ethernet ELAN, its MAC address will
default to the ESI (Ethernet format).
To display the BIA (ESI) of the M770 ATM Switch, use the
address esi
command.
Command:
M15-155s8:/>ip gateway <ip_address>
Example:
M15-155s8:/>ip gateway 192.32.220.8
Parameters:
<ip_address>
A valid IP address for the gateway.
Command:
M15-155s8:/>ip show
Output:
IP address: 192.32.220.61 (The address was obtained
using BOOTP.)
IP subnet mask: 255.255.255.0
IP gateway address: 192.32.220.8
MAC address: <valid address> (or initializing)
Layer 2: ok (or initializing)
Command:
M15-155s8:/>address esi
Output:
Switch ESI Address (Ethernet Format): 00.40.0D.07.00.0e