Lucent Technologies CAJUN M770, User Manual

Page: 232 / 266

Chapter 19 Upgrading Cajun M770 ATM Switch Software
214 Cajun M770 ATM Switch User’s Guide
Deleting a file from the flash memory bank
To delete a file from the flash memory bank, use the
flash delete
command. You
will be asked to confirm the deletion.
Note:
Once a file is deleted it cannot be recovered. The file must be downloaded
again. You must not delete the config.data file during normal operation, as this will
reset all the LANE configuration on the module.
If you want to reset the module’s LANE parameters to the factory defaults, delete or
rename the
config.data file. The module will create a new config.data file based on
LANE factory defaults.
Renaming a file in the flash memory bank
To rename a file in the flash memory bank, use the
flash rename
command.
Command:
M15-155s8:/>flash delete <filename>
Example
M15-155s8:/>flash delete m770ATM
Parameter:
<filename>
The name of the file you wish to delete from the
flash directory.
Command:
M15-155s8:/>flash rename <old_name> <new_name>
Example
M15-155s8:/>flash rename m770ATM fieldrelease
Parameters:
<old_name>
The current name of the flash file.
<new_name>
The new name you wish to assign to the file.