Lucent Technologies CAJUN M770, User Manual

Page: 205 / 266

Chapter 16 Managing an ELAN
Cajun M770 ATM Switch User’s Guide 187
Creating an ELAN client mapping
When you create a new ELAN client mapping to a specific ELAN, first you must
decide whether it is a single LEC or a group of LECs that is to be mapped.
You must then decide what type of ELAN mapping to use. Possible mapping types
are:
•
An ATM address: the mappings refer to a specific LEC or a group of LECs.
• An alias ELAN name: the mappings refer to a specific LEC or a group of LECs.
• A MAC address: the mappings always refer to a specific LEC.
To create a new client mapping for a LEC ATM address, use the
lane elan client
create atm
command:
Command:
M15-155s8:/>lane elan client create atm <address value> <address mask> <ELAN name>
Example 1:
Example 2:
The following example shows how to map a specific LEC to the ELAN
accounts_elan:
M15-155s8:/>lane elan client create atm
39.84.0F.80.01.BC.61.DF.00.07.80.20.00.00.00.6F.07.80.20.00
FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF.FF
accounts_elan
This example shows how to map all LECs whose addresses begin with a specific
prefix to the ELAN
accounts_elan:
M15-155s8:/>lane elan client create atm
39.84.0F.80.01.BC.61.DF.00.07.80.20.00 13 accounts_elan
Parameters:
<address
value>
The full 20-byte ATM address.
<address mask>
The portion of the <address value> that needs to match the
LEC's ATM address for the mapping to apply.
The <address mask> is either entered as a number, (for
example, 15 indicates that the first 15 bytes of the <address
value> is to be masked), or you can use FF to indicate the
byte of the <address value> that is to be masked and 00 to
indicate the byte of the <address value> that is not masked.
When using the mask as a number, note that the number of
bytes entered in the address value should be limited to this
number.
<ELAN name>
The name of the ELAN known to the LECS.