Lucent Technologies CAJUN M770, User Manual

Page: 195 / 266

Chapter 15 Managing the LES/BUS
Cajun M770 ATM Switch User’s Guide 177
To change the registration mode of the LES, enter the
lane les mode
command.
Note: For information about the proprietary “automatic LES address
determination method”, see Creating a new LES earlier in this chapter.
Note:
The above command will take immediate effect. The command must be used
with care as all LECs will be thrown off the ELAN hosted by the LES.
Viewing the LES registration mode
To display the registration mode of a LES, use the
lane les mode
command.
Command:
M15-155s8:/>lane les mode <elan-name> {distributed | standby | manual}
Example:
M15-155s8:/>lane les mode marketing_eth standby
Parameters:
<elan-name>
The name of the ELAN that currently hosts the
LES that you wish to change. This parameter is
case-sensitive.
distributed
The LES will register with the LECS using the
proprietary “automatic LES address determination
method” and will act as a distributed LES.
standby
The LES will register with the LECS using the
proprietary “automatic LES address determination
method” and will act as a “single” mode LES but
support standby resilient LES.
manual
The LES will use the ATM Forum-compliant
method to manually register the LES with the
LECS.
Command:
M15-155s8:/>lane les mode <elan-name>
Example 1:
M15-155s8:/>lane les mode M770ElanEth
Output:
LES ‘M770ElanEth’ registers automatically
The LES can act as a standby LES
Example 2:
M15-155s8:/>lane les mode M770ElanEth
Output:
LES ‘M770ElanEth’ registers automatically
The LES can act as a distributed LES