Lucent Technologies CAJUN M770, User Manual

Page: 188 / 266

Chapter 15 Managing the LES/BUS
170 Cajun M770 ATM Switch User’s Guide
To create a new LES in the switch, use the
lane les create
command. For
definitions of the various LES modes, see “changing the LES registration mode”
later in this chapter.
Note:
Each selector entered, when creating a LES, must be unique on the switch.
You can use the
lane les show
command to view a list of all selectors currently in
use. Selectors 7f, 80 and 81 are reserved for special use and cannot be used for the
LES or BUS.
Note: The LES name should be the same as the hosted ELAN name.
Note:
Lucent strongly recommends that you use distributed LES/BUS services instead
of resilient.
Command:
M15-155s8:/>lane les create <elan-name> <mode> <type> <les-selector> <bus-selector>
Example:
M15-155s8:/>lane les create marketing_eth distributed ethernet 82 83
Parameters:
<elan-name>
Enter the name of the ELAN that the new LES will
host. The ELAN name should be unique within the
ATM network. This parameter is case-sensitive.
<mode>
Enter the mode type as either “distributed”,
“standby”, or “manual”. See above explanation for
correct mode usage.
• distributed - automatic registration for distributed
LESes.
• standby - automatic registration with standby
support.
• manual - manual registration.
<type>
Enter the type of LES ELAN as “ethernet”.
<les-selector>
Enter the 1 or 2 digit hexadecimal ATM selector for
the LES.
<bus-selector>
Enter the 1 or 2 digit hexadecimal ATM selector for
the associated BUS functions.