Chapter 10
Managing PNNI Routing
Cajun M770 ATM Switch User’s Guide
127
The PNNI peer group ID is used when the PNNI protocol constructs the peer groups
in which topology databases are being synchronized. A link between two neighbors
that share the same peer group ID is considered an inside link, and a link between 2
PNNI nodes that don’t have the same peer group is considered an outside link.
Topology databases are synchronized only over inside links.
Setting PNNI peer group ID
Use the following command to set the PNNI peer group ID.
Setting PNNI peer group ID to default value
Use the following command to set the PNNI Peer Group ID to its default value. The
default value is derived from the PNNI level and the switch’s prefix. The first byte of
the peer group ID is the level indicator. The following bytes must be prefixes of
ATM End System Addresses as defined in the PNNI specification (af-pnni-
0055.000). The peer group is encoded with the 104-n rightmost bits set to zero,
where n is the level.
PNNI node Restricted Transit
A PNNI node may be administered to be restricted transit. This will restrict calls
from going through this node, but will not restrict calls to be set from/to
endstations connected to the node directly. This feature may be used by network
administrators to imply some policy over the network.
Showing PNNI node restrict transit flag
Use the following command to show pnni node restrict transit flag:
Command:
M15-155s8:/>route pnni config pg_id set
60.39.84.0f.80.01.bc.61.de.81.00.00.78.00
Examples:
Warning: This request will change the peer group id.
It will also change the node level and the first byte
of the node id to 0x60.
Changes won't take effect until a switch reboot is
performed (system reboot switch).
Do you want to continue (Y/N)?
Command:
M15-155s8:/>route pnni config pg_id default
Examples:
This request will set default value (extracted from ATM
address) for peer group id.
Changes won't take effect until a switch reboot is
performed (system reboot switch).
Do you want to continue (Y/N)?
Command:
M15-155s8:/>route pnni config restrict_transit show
Examples:
Restrict Transit:
Current : No
Summary of Contents for CAJUN M770
