Lucent Technologies 4ESS SCS, Maintenance Manual

Page: 67 / 526

TAP-105 234-151-077AC
4 of 1 Page 1999 June 7, Issue
Circuit Service at Failure Diagnostic Clear
Data Raw Analyzing by (SCC) Controller
Packs Suspect Any Replacing and
Summary: and used were subroutines if Determine prologue. phase failing first the Read
function. test the determine and test failing first the Locate function. and location their identify
the of knowledge Use function. and location their identify and used were doloops if Determine
Trouble the on those than other packs suspect any replace and identify to function test failing first
procedure the use cleared, not is trouble the If replaced. previously list (TLP) Procedure Locating
the locate to tracing signal use and test failing first the over looping by failure diagnostic clear to
fault.
phase. failing first the for PIDENT diagnostic the of prologue the Read 1.
Note: = (xx SCU the for SVXX PUDG and SCC the for SSXX PUDG is PIDENT
for PUDGSVGR and SCC the for PUDGSSGR in are Subroutines number). phase
SCU. the
test. failing first the of data raw the locate 1), Figure (see printout raw-data the On 2.
data. mismatch the following word data fifth the in digit sixth the record and Locate 3.
subroutines)? (no zero 3 Step in recorded digit the Is 4.
If NO 5. Step to continue ,
If YES 6. Step to go ,
(DLP-518). subroutines of function determine and Locate 5.
1.) Figure (See data. mismatch following word raw-data fourth Locate 6.
Proprietary — Technologies Lucent
instructions Company to pursuant Use