ISDN DEFINITY
Extender 2300EU/2100EU
37
AT Command Set
Terminal Adapter Configuration Commands
cont’d
Command
Description
Values
Xn
Connect Messages - allows only a
subset of all result messages to be
displayed
n=0- Enable result codes
0-4
1- 0-4, 17, 19,
2- All result codes
<default>
Refer to the AT result
codes section for a
description of the codes
S0=
Auto answer - does the module
automatically answer an incoming
call or wait for the AT answer
command to be issued before
answering
0 - auto answer disabled
<default>
1-255 auto answer
enabled
S1=
Ring count. The value of this
command never increments.
000 (Compatible with
BitSURFR command
lines)
S2=
Escape character - defines the
value of the escape character that
may be used to exit from the
online mode. If there is no data
for an interval greater than or
equal to the Guard Time and then
three consecutive escape
characters are received, the
module will return to the AT
command mode from the online
mode while keeping the data
connection alive.
0-127 – The specified
character is the escape
character (default = 43)
128-255 – the escape
feature is disabled
S3=
Carriage return character
0-127 (default = 13)
S4=
Line feed character
0-127 (default = 10)
S5=
Backspace character
0-127 (default = 8)
Table 3. Terminal Adapter Configuration Commands Cont’d
