ISDN DEFINITY
Extender 2300EU/2100EU
32
2100EU TA Configuration
Introduction
The following configuration parameters are for use only
if you are using the 2100EU as a terminal adapter for
dial-up networking.
The parameters that may require configuring are (the
defaults should be acceptable in most environments):
•
Data Rate
•
•
•
Changing
Terminal
Adapter
Settings
This section describes the steps involved to program the
terminal adapter configuration.
NOTE: You must be in the Menu on the Switch Module
to configure the terminal adapter settings.
1.
From the Configure System menu select COM. All
COM port settings are configured at one time.
2.
Press Enter.
Setting The
Data Rate
To set the Data Rate:
1.
Highlight the data rate you require. Data rate options
are: 2400, 4800, 9600, 115.2, 19200, 38400, 57600
and 115.2 kbps.
The default rate of 57600 kbps is recommended.
2.
Press Enter.
NOTE: Selecting a data rate slower than 57600 kbps may
cause some connection problems.
When you make your selection, the Parity menu will
appear.
