ISDN DEFINITY
Extender 2300EU/2100EU
11
Quick Configuration
Configuring
And
Installing
The Switch
Module
cont’d
The RS232 parameters default at 9600 bps, 8 data
bits, 1 stop bit, and no parity and use VT100 terminal
emulation mode.
4.
Plug in the 220/240 volt AC adapter provided with
the Switch Module.
The Module’s LED will start flashing and performing
the power-up test.
The Module’s LED will perform a series of yellow,
green and red blinks. After 10 seconds of very fast
red blinking, the LED will blink green three times
and red once. The LED will then blink 3 sets of 8
yellow flashes.
NOTE: You can only access the menu on power up.
5.
During this yellow flash sequence type the word
MENU.
After you have entered the command, the Switch
Configuration menu will appear on the terminal program.
6.
Select Configure ISDN to configure the following
ISDN parameters:
•
The ISDN network switch type. Currently only
ETSI NET 3 is available.
•
The DN1 and DN2 numbers for the Switch ISDN
line.
•
TEI type (auto, fixed).
•
TEI1 if fixed TEI type was selected.
Continued on the next page…
