ISDN DEFINITY
Extender 2300EU/2100EU
14
Configuring Using a Terminal
Introduction
The Switch Module can only be programmed using a
terminal.
The following Switch Module parameters require
programming using a PC:
•
ISDN Parameters – Switch Type, DN, and TEI.
The following Switch Module parameters are optional but
also require programming using a PC:
•
COM Port – Data Rate, Parity, Data Bits, Stop Bits.
(Optional)
For the 2300EU, the COM Port settings are for the serial
data connection that shares the first B channel. For the
2100EU the COM Port settings are for the RS232 data
port that uses the second B channel.
Requirements
When configuring the Switch Module, ensure the PC or
terminal has its communications parameters set to:
•
9600 BPS
•
No parity
•
8 bits
•
1 stop bit
The Switch Module must be connected to the PC or
terminal using an RS232 serial cable, which connects to
the RS232 port on the module. Your terminal
application should be configured for VT100 emulation.
