Installation Instructions
SKU# 020276 (MD112810-21A)
Rated Voltage INPUT: 220-240V~, 50Hz OUTPUT: 12V, 420W
THANK YOU FOR PURCHASING THIS QUALITY LUCCI PRODUCT, TO ENSURE CORRECT
FUNCTION AND SAFETY, PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE
PRODUCT AND KEEP THE INSTRUCTIONS FOR FUTURE REFERENCE.
WARRANTY:
This light fitting is covered by a 12 month warranty; please retain proof of purchase and evidence of
installation by a licensed electrician.
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
INSTALLATION REQUIREMENTS:
Must be installed by a licensed Electrician.
Must be installed according to the current wiring rules AS/NZS3000.
This fitting is a Class I product and must be earthed.
Do not exceed the maximum wattage rating.
This product is suitable for indoor use only.
The mounting point must be able to support 4 times the weight of the fitting.
This fitting may not be suitable for dimming, may cause buzzing sound in some areas.
A clearance of 0.5m should be kept between the globe and nearest object/wall/ceiling.
Check the installation circuit is appropriately rated for the fitting.
INSTALLATION DIRECTIONS:
Take care not to pull any electrical wires during unpacking as this may damage the connection.
Lay out all the components on a sm
ooth surface and make sure there is no component’s missing before
assembling.
Check whether the fitting has been damaged during transport. Do not operate/install any product which
appears damaged in any way. Return the complete product to the place of purchase for inspection,
repair or replacement.
Ensure all power to the circuit you are working on has been switched OFF.
Select a suitable location for installation. Ensure the fitting is not installed next to any air vents and is not
in any moist or damp areas. Ensure the mounting surface can hold 4 times the weight of the fitting.
1. Remove the mounting bracket from the canopy by loosening the screws on the side.
Use the mounting bracket as a template to mark the screw positions onto the ceiling.
Drill holes into the ceiling and push the anchors into the holes.
Install the mounting bracket onto the ceiling using appropriate sized mounting screws.
Ensure the screws used are suitable for the mounting surface.
2. Connect the mains supply wire to the light fitting using the terminal block provided. Ensure that the wires
are secure and no bare wires are exposed.
Mains Supply Wire
Fitting Wire
Earth
– Yellow/Green
Yellow/Green
Neutral
– Blue or Black
Blue
Live
– Brown or Red
Brown
3. Slide the crystal over the lamp holder and lock into position by tightening the bracket end.
Install the bulb into lamp holder. Do not touch the bulb with your bare hands, as it may decrease the life
of the bulb. Use gloves, tissue or a clean cloth.
4. Turn on power and enjoy your new lighting product.
