Installation Instructions
1 |
P a g e
v 1 . 0 ( 0 7 / 2 0 2 1 )
TUGRAH FLOOD LIGHT
SKU# 239608
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
•
This luminaire is covered by a 3-year warranty. The warranty is from the date of purchase, not the date of installation.
•
If the luminaire is not assembled and installed by a licensed electrician, the warranty will be void.
•
Please retain the proof of purchase and evidence of installation by a licensed electrician for any warranty enquiries.
•
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
•
This luminaire is not suitable for use with dimmer switches. Warranty will be void if the luminaire is used on the same
circuit, which has a dimmer switch.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.
Installation Requirements
•
This luminaire must be assembled and installed by a licensed electrician.
•
All wiring and installation of the luminaire must adhere to the latest local and national wiring rules.
E.g. AS/NZS 3000 Electrical Installations.
•
This luminaire is a Class II product, this must be maintained during wiring and installation.
•
This luminaire is rated IP44 and must be maintained during wiring and installation of the luminaire.
•
Select a suitable location for installation:
−
The mounting point must be able to support 2 times the weight of the luminaire.
−
This luminaire is rated against water penetration to IP44 standards, which is water splashing from any direction.
−
It is recommended the luminaire is installed on its own switch and not interconnected with other luminaires on the
same switch, as it may cause the luminaire to switch on unintentionally.
−
Avoid installing the luminaire in close proximity or on the same circuit to any fluorescent luminaires or ceiling fans.
RFI interference may cause the luminaire to switch on unintentionally.
−
See the
Sensor Information
section in this instruction manual for additional information about the sensor detection
range and sensitivity, to select a suitable installation location.
•
The luminaire is not suitable to use with dimmer switches and must not be used with a circuit which has a dimmer.
•
The luminaire must not be used if the protective shield or shade has been cracked or damaged.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
