Installation Instructions
1 |
P a g e
RIBBON II
SKU# 170552, 170557
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before using the product. Please keep instructions for future reference.
Warranty
This light fitting is covered by 3 years warranty. Please retain proof of purchase and evidence of installation by a
licensed electrician.
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
Installation requirements
This product is a DIY (do it yourself), no electrical wiring connection or disconnection is required. It can be installed
to the mains power socket outlet.
All wiring and installation of the light fitting must adhere to local and national wiring rules.
eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
Do not exceed the maximum wattage rating.
Select a suitable location for installation;
- LED ribbon is rated IP65, and suitable for indoor and outdoor use.
- Power adaptor, supply cable and connector must be installed indoor, or located away from rain or wet
environments.
Take care not to pull any electrical wires during unpacking as this may damage the connection.
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Ensure power to the circuit you are working on has been switched OFF.
Installation directions
1. Remove all packaging material from the product.
2. Find an indoor place to fix the power adaptor.
3. Fix the LED ribbon by double side tape or ribbon anchorages.
4. Connect the LED ribbon to IR controller.
5. Connect the IR controller to power adaptor.
6. Connect power adaptor to power supply.
