Installation Instructions
1 |
P a g e
v 1 . 0 ( 0 5 / 2 0 2 0 )
FORBES LED TABLE LAMP
SKU# 269410, 269411
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this luminaire. Please keep instructions for future reference.
Warranty
•
This portable luminaire is covered by a 3-year warranty valid for in-store replacement or refund only.
•
The warranty period starts from the date of purchase. Please retain the proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the portable luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the warranty.
Installation Requirements
•
Select a suitable location for this portable luminaire:
-
Ensure it is on a flat and stable surface.
-
This portable luminaire is suitable for indoor use only.
-
Do not place flammable material near or over the portable luminaire.
-
Ensure the portable luminaire is not installed in direct line of an air vent/system.
-
This luminaire is rated against water penetration to IP54 standards, which is water splashing from any direction.
NOTE: The plug-in charger is rated IP20 and has no protection against water penetration
.
NOTE: Charging cable and plug-in charger must not be in use for the luminaire to be rated IP54.
NOTE: Plastic cover must be secure over the micro USB charging port for the luminaire to be rated IP54.
-
If the portable luminaire is placed in an area prone to moisture, ensure that the area is well ventilated, and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Do not plug into the mains power socket outlet before or during assembly. Only do so after the portable luminaire is
fully assembled and is ready to use for the first time.
Installation Directions
1.
Remove all packaging material from the product and accessories. (Fig. 1)
2.
Pull back the plastic cover from the micro USB charging port. (Fig. 2)
3.
Insert the micro USB end of the cable into the portable luminaire. (Fig. 3)
4.
Insert the plug-in charger into the mains power socket outlet and ensure it is fully plugged in. (Fig. 3)
5.
Turn on the mains power socket outlet.
6.
Press the touch switch (short press) to turn the portable luminaire ON/OFF. (Fig. 4)
Press and hold the touch switch (long press) to adjust the brightness of the portable luminaire.
