Installation Instructions
1 |
P a g e
V 1 . 0 ( 0 6 / 2 0 1 8 )
SUNSET SOLAR LED REC WALL SCONCE WITH SENSOR
SKU#240741
Rated Voltage 3.7 VDC
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this luminaire. Please keep instructions for future
reference.
Warranty
•
This luminaire is covered by a 3 year warranty. The warranty is from date of purchase, not the date of installation.
•
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void
warranty.
Installation requirements
•
Select a suitable location for installation;
- This product is suitable for outdoor use only.
- This product is protected against water penetration to IP44 standards, which is splashing in every direction and
is not designed to be immersed in water.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Installation directions
1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material.
2. Use the mounting bracket as a template to mark the screw positions onto the wall. Drill holes into the wall and push
plastic anchors into the holes. (Fig.1)
3. Install the mounting bracket onto the wall by using the mounting screws. Ensure that the anchors and mounting
screws used are suitable for the mounting surface. (Fig. 2)
NOTE: Choose a best installation position where the sensor can detect the body motion movement.
NOTE: The ideal mounting height for the fitting is between 1.5m to 2.3m above the detection area.
NOTE: The detection area is approximately 6 metres away at an angle of 90° wide. This may vary depending on the
mounting height and location.
4. Turn the ON/OFF switch to the ON position. Then the solar panel can charge the battery under sunlight when the
ambient light level is higher than 20 lux. When there is no sunlight and the ambient light level is below 20lux, the
luminaire will activate the detect function. And when detect the body movement, the LED will light up and lasting for
40s.
NOTE: If you want to test the detection area of the PIR sensor, please wait for the ambient light level is below 20 lux,
Or cover the solar panel by light-proof material.
5. Secure the luminaire on the mounting bracket using the hooks on the mounting bracket. (Fig. 3)
