Installation Instructions
1 |
P a g e
v 1 . 2 ( 1 2 / 2 0 2 1 )
BRETON 3LT FLOOR LAMP
SKU# 281041, 281044, 281050, 281051
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep the instructions for future reference.
Warranty
•
This portable luminaire is covered by a 12-month warranty valid for in-store replacement or refund only.
•
The warranty period starts from the date of purchase. Please retain the proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the portable luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.
Installation Requirements
•
Select a suitable location for this portable luminaire:
-
Ensure it is on a flat and stable surface.
-
This portable luminaire is suitable for indoor use only.
-
Do not place flammable material near or over the portable luminaire.
-
Ensure the portable luminaire is not installed in direct line of an air vent/system.
-
If the portable luminaire is placed in an area prone to moisture, ensure that the area is well ventilated, and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.
•
Do not exceed the maximum wattage rating.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure no components are missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Do not plug into the mains power socket-outlet before or during assembly. Only do so after the portable luminaire is
fully assembled with the globe installed and is ready to use for the first time.
Installation Directions
1.
Remove all packaging material from the portable luminaire.
2.
Remove the shade (A) from the base (D) and remove the plastic wrap from the shade (A).
3.
Install globes (B - not included) into the lamp holders (C). Do not exceed the maximum wattage rating.
4.
Install the shade (A) back on to the base (D).
5.
Select a suitable location for the portable luminaire. See the installation requirements above.
6.
Insert the plug (F) into the mains power socket outlet and ensure it is fully plugged in.
7.
Turn power on at the mains power socket outlet.
8.
Use the cord line switch (E) to turn the portable luminaire on/off.
