PNEUMATIC PRESSURE SPRAYER
MANUAL
1650300
(PS030)
REV 11/12/14
1
WARNING
Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety
rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required. Keep
these instructions to assist in future servicing.
SAFETY PRECAUTIONS
GENERAL SAFETY RULES
WARNING:
Read and understand all instructions.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions or situations that could occur.
It must be understood by
the operator that common sense and caution are factors which cannot be built into this product, but
must be supplied by the operator.
WARNING
• Do not deliver corrosive or flammable liquids.
• Do not expose the tank to heat sources
• Do not modify any component of the equipment.
• Periodically check the correct operation safety valve.
• Max.working pressure:8 Bar.
OPERATION
• Unscrew cap (B) and fill reservior(3/4 its capacity) with selected liquid using the funnel supplied.
• Screw cap (B) close ball valve (A). Connect compressed air to quick coupler (D), open the ball
valve (K) until manometer (F) gives a pressure of 7-8 bar.
• To spray liquid,open ball valve (A).
WARNING
• Before opening the cap (B),
always discharge the reservoir
compressed air by opening
ball valve (K).
A(open
）
F
B
K
（
open
）
D
C
K
（
closed
）
A(closed
）
IMPORTANT
Normal steel pressure sprayers accept
all type of solvent, but will not accept
acids.Never use inflammable products.
