![background image](http://html1.mh-extra.com/html/lts/cmip7442w-28m/cmip7442w-28m_user-manual_1945237078.webp)
User Manual of Network Camera
78
And you can select the directions as A<->B, A ->B, and B->A.
A<->B
: Only the arrow on the B side shows; when an object going across the plane
with both direction can be detected and alarms are triggered.
A->B
: Only the object crossing the configured line from the A side to the B side can
be detected.
B->A
: Only the object crossing the configured line from the B side to the A side can
be detected.
4.
Set the sensitivity [1~100].
5.
Choose another line crossing on the dropdown list to configure. Up to 4 line
crossing areas are configurable.
6.
Click
Save
to save the settings.
6.6.7
Configuring Intrusion Detection
Intrusion detection can set an area in the surveillance scene and once the area is
been entered, a set of alarm action is triggered.
Steps:
1.
Check the
Enable Intrusion Detection
checkbox.
2.
Click
Draw Area
, and then draw a rectangle on the image as a defense region.
Note:
when you draw the rectangle, all lines should connect end to end to
each other. Up to four areas are supported.