Quick Operation Guide of 0700/8800/8700 Series NVR
2
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to
8700, 8800 and 0700 series NVR.
NVR Pre-Installation
The 0700/8800/8700 series NVR are highly advanced surveillance equipment that should be installed with care.
Please take into consideration the following precautionary steps before installation of the NVR.
1.
Keep all liquids away from the NVR.
2.
Install the NVR in a well-ventilated and dust-free area.
3.
Ensure environmental conditions meet factory specifications.
4.
Install a manufacturer recommended HDD.
NVR Installation
During the installation of the NVR:
1.
Use brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect both the alarm and RS-485 cable.
5.
Allow at least 2cm (~0.75-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of -10
º
C ~ 55
º
C, 14º
F ~ 131º
F.
8.
Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory recommended HDD
should be used for this installation.
Up to 8 SATA hard disks can be installed on your NVR.
Tools Required:
Screwdriver.
Steps (for 0700):
1.
Fasten the hard disk mounting handle to the hard disk with screws.
2.
Insert the key and turn in clockwise direction to open the panel lock.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
