Quick Operation Guide of 0700/8800/8700 Series NVR
26
Startup and Shutdown
Proper startup and shutdown procedures are crucial to expanding the life of the NVR.
To start your NVR:
1.
Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an
Uninterruptible Power Supply (UPS) be used in conjunction with the device. The Power LED on the front
panel should be red, indicating the device gets the power supply.
2.
Press the POWER button on the front panel. The Power LED should turn green. The unit will begin to start.
To shut down the NVR:
1.
Enter the Shutdown menu.
Menu > Shutdown
Shutdown Menu
2.
Select the
Shutdown
button.
3.
Click the
Yes
button.
Using the Start Wizard
By default, the Setup Wizard starts once the NVR has loaded, as shown in Figure below.
Start Wizard Interface
Operating the Setup Wizard:
1.
The Setup Wizard can walk you through some important settings of the NVR. If you don’t want to use the
Setup Wizard at that moment, click the
Cancel
button. You can also choose to use the Setup Wizard next
time by leaving the “Start wizard when NVR starts?” checkbox checked.
2.
Click
Next
button on the Wizard window to enter the
Login
window.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
