LSI Mylex PCI Disk Array Controllers Driver, Installation Manual

Page: 91 / 104

Solaris
Manual No. DB11-000030-00 7-15
7
S
O
L
A
R
I
S
Quick Driver Update Instructions for a Secondary
Installation
☛
Note
In order to use this quick installation, you will need
access to the Common Desktop Environment (CDE)
with Solaris 7 or Solaris 8.
When you are working with a CDE, you can update your Mylex drivers with
a just a few clicks on the main menus and icons.
Follow the steps below:
1. Insert the MDAC Supplemental Driver diskette in the floppy drive.
2. Access the File Manager screen.
3. From the File Manager screen, click on File to access the pull down
menu.
4. Click on “Open Floppy.”
5. Double click on the next series of icons:
/DU/Sol_27/i86pc/Tools/install.sh -i (Solaris 7)
/DU/Sol_28/i86pc/Tools/install.sh (Solaris 8)
6. The Run screen will be displayed. At the bottom of the screen, you will
see the following message:
“Installation of <MYLXmdac> was successful”
7. When the installation is complete, close the Run screen and Reboot the
system to activate the new updated driver for your Mylex controller.
Congratulations! Using a CDE, you have successfully completed the a
secondary installation of drivers for your Mylex controller.